Alex said there may be other reasons for the fuse to be blown.I can think of two-you may have lost the rf pa or the audio output stage.In either case the fuse will go tu.

I forgot to mention there are two on 880 meg band--857.5125 and 862.2125-high and low power.Paul

There are frequencies for low power use-some high power ones too.Industry Canada does usually not get too upset if users are licenced on them or not although licencing is still required.The low power ones are 151.055,151.085,151.115,151.1,154.57.154.49.The high and low power ones are 167.73,170.94 ...

Goodday.I have run into this problem before.You have probably got a bad flex circuit on the side of the radio.If you look at the side of the radio with the side buttons facing you and the radio controls on your left hand-there are five contacts on the bottom of the flex.Solder a wire fom the first ...

does the transmit light come on?if you have a scanner listen to see if you can hear anything on it in the way of a transmitted signal.maybe its another module.paul

Something funny in the vco?Maybe replace it if you have a spare.paul

Hex editing will tell you if they will lock.If not hardware mods are required.A person would need to sit down and look at the circuitry to do tha hardware mods.I have been looking to buy a couple of these on this band split.If you would be willing to sell me two and give a price I would be grateful ...

Thats pretty expensive Pride and Joy.Paul

If you take out the two screws from the bottom of the radio and remove the case you will see the press to talk switch on the side of the radio.The little metal dome that makes up part of the switch is held on by scotch tape. Cut the tape around the dome and take out the dome.Dont loose it.You can ...

otter9309 wrote:I have a saber 1 uhf that will not read or write. The TX light stays on when powered up.

TIA
Steve

try collapsed dome on ptt switch.hareless

On one side of the radio is a green circuit board.On this board is a pot that is labelled pwr adj.Tune for maximum smoke er power output.Paul

Have you tried gp300 lab or hex edited software that needs no serial number?