I have a convertacom for my saber, i use the saber mike with the led display, i do my own programming , i would like to know how i can program the keys on the mike the number is NMN6150A. Will i be able to change channels on my saber with this hand mike , or just what will i be able to do using this ...

Does anyone know if the following mics will work with both these applications.
HMN1035B
HMN4069D
WILL THESE WORK WITH A SABER CONVERTACOM AND A MSC2000

I HAVE A HMN4072D THAT DOES WORK ON A MSC 2000

IS THERE A LIST OF MOTOROLA MICS AND THERE RADIO APPLICATIONS ANYWERE TO BE FOUND.

THANK YOU ...

where did you get the cable? have you tried it on a different radio? i've seen people wire the rj45 backwards, nobody ever gets pin 1 in the right spot.


Yes i have tried it on 2 radios with the same results . I followed the cable directions and i am sure the connector and cable are write. anu ...

I AM TRYING TO PROGRAM MY MSC2000 THRU THE RJ45 AT CONTROL HEAD. WHEN I LOAD THE SOFTWARE , MOTOROLS 2005 VER WINDOWS, I CONNECT TO READ RADIO AND THE CONTOL HEAD TURNS TO PROGRAMMING BUT A COMMUNICATIONS FAILED WINDOW OPENS. I HAVE CHECKED THE CABLE AND AS PER THE DIAGRAM IT IS RIGHT , COM PORT ...

where can i find a list of power amp part numbers and wattage for sabers 1 -11

When replacing a power amp with a higher output amp is there any other changes ( parts\software ) that need to be done .

thank you
allen

a.steggall wrote:Are you using the systems saber RSS or the regaler saber RSS? Becaues the systems saber's use there own RSS.

it says system saber ro4.0

I have a system saber 11 with a broken led. it transmits on 446.727
i have tryed to reprogram it using ver Ro 4.00, ver 6.0,ver 7.01 and it comes up with an error serial bus i/o error. i can put a diff saber on it and it reads fine. can anyone help figure this out.
allen

It says system saber ...

I have a system saber 11 with a broken led. it transmits on 446.727
i have tryed to reprogram it using ver Ro 4.00, ver 6.0,ver 7.01 and it comes up with an error serial bus i/o error. i can put a diff saber on it and it reads fine. can anyone help figure this out.
allen