Batboard

Bruce1807

USQ is unsquelched

Bruce1807

If it is coiled it will get a little warm. If it is run out it will work just fine.

Bruce1807

What you have is a hi end T-Pass combiner. Really good quality woth several thousand dollars, however how much need is there for 900 Mhz stuff these days?

Bruce1807

We use ours as Zone select

Bruce1807

i have about a 60ft cable from the office to the install bay, never had a problem but then ive never been game to do a flash upgrade.

Bruce1807

Any radio sent for repair that needs a controller fix comes back 8 Meg
but yeah an upgrade to 10.00 is no go unless you have the 8 meg board

Bruce1807

post a photo

Bruce1807

DES-AJ wrote:Just for the record my XTS2500 Impres batteries charge fine in a ver 3.3 single impres charger.

im sure they do but 3.4 was the release for xts2500 so maybe the charge dammm fine with 3.4

Bruce1807

also depends on wether or not you have an 8 meg or a 4 meg board

Bruce1807

30 amps may get a little warm

Bruce1807

Hope they are not IS radios as they wont br if you make a mod like that!

Bruce1807

Heating loss! How about fire risk. Depends what sort of current you intend to draw and what rating the cable is as well as how much is opn the coil etc. Guidelines from mine safety to consumer groups say dont use it coiled. Then again if its low current what the hell! Problem is when more and more g...

Bruce1807

a shuffled band plan is simply The control channel says on go to channel RF channel 6. My radios says ok :wink: :wink: and goes to RF channel 9 where the conversation takes place. basiclly the control channel is performing some very basic coding that is easy to crack and im sure the next lot of scan...

Bruce1807

What should be a much higher priority is USEFUL IMPRESS MANAGEMENT SOFTWARE? Not the software for a single charger like was displayed at APCO. I need to be able to connect all my rack chargers across the city (via the 15 pin on the back to a network plug) to a central computer Soon come. It was dem...

Bruce1807

audio out is on the accessory connector.
From there it is simple to add an amplifier or whatever.

Bruce1807

if the patch is trunked , no problem

Bruce1807

When we upgraded our MSF's I ordered 5 Quantros without the PA's.
then put in the MSF PA's.
no problem.
you also need the MSF PS as well

Bruce1807

The upgrade from II+ CRT to ELite was return the CIE and get a new one at a discount.
Based on this and that the circuitry is very different no.

Bruce1807

actually its VSWR
1 is perfect
under 1.5 is acceptable

Bruce1807

I agree its the same firmware but how about the boot system or whatever the real embeded code is in.
I actually asked at the Orlando MTUG last year when the 1.5 was formally introduced as I wanted to migrate my 1 to 1.5's
I asked the guy that did the subscriber presentation and that was his answer.

Bruce1807

If you use full spectrum scan you dont need to add any frequencies as the radio will look for a valid control channel and system id and work it out for itself.

Bruce1807

It can also do emergency call as well as emergency alert depending on how the system manager wants the system to work.
We only use call.

Bruce1807

I enquired about making a model 1 XTS2500 into a 1.5 and was told that whilst the hardware supported it there is no display driver in the firmware.
I never tried swapping a case to see what would happen.

Bruce1807

1. Can someone explain the pros and cons of VHF vs UHF vs 800 Mhz? For example does one band work better for certain terrains and others better for distance? VHF is better for open terrain, UHF for Urban areas and 800 , it very short range and needs a repeater or a system. 2. I have been looking at...

Bruce1807

You dont need frequencies what you need is a system key ( an encrtpted file with the id). If it is P25 contact your local system administrator. you also need to look at your flashcode and see if it 9600 trunking or just 3600. This is assuming that your neighbours have gone P25 trunking. Will be much...

Bruce1807

tessco.com sells reverse connectors.

Bruce1807

na, just got a eurocopter for 1.8

Bruce1807

HKN6192A CBL, C/H FLEX ASSY (DASH) should cost ya about 15.00

Bruce1807

well the til solution is about 10,500 with one radio(P25, des-ofb,sz) so add 2 more radios at abou 3 grand a piece
he should get out of it for say 17,000.

Bruce1807

it has been inhibited. contact your system administrastor.
it is probably stolen or lost.

read it and write it again depending on what version it was programmed with

Bruce1807

theres another helicopter one that takes three XTL5000 W9's and converts them to one control head. I will post the link tomorrow when I'm back at work. The Control head in the new NSW Ambo's rescue choppers(CHC) are called a NAT TH450B control head that can fully control 4 radios via the 1 display!...

Bruce1807

not really as you would normally use 0dB antenas to keep them small. the til.com solution uses XTS5000 which gives you 4 or 5 watts max. At least this way we get 10 watts. Our lot just bought a Eurocopter and my first task is to sort out the radios. I intend on 2 x XTL5000 radios with the low power ...

Bruce1807

theres another helicopter one that takes three XTL5000 W9's and converts them to one control head.

I will post the link tomorrow when I'm back at work.

Bruce1807

if its trunked it may of been channel locked by the controller

Bruce1807

hold it for about 2 years. It will also have data mining, great reports and if someone makes net work on macs it will transfer and run. It was actual private sessions with the developers so there was loads of user input It will do do mobile and portable with the same software Also on show was a comp...

Bruce1807

Alex sorry I didn't make it. I missed my connection in Charlotte and didnt get in till about 1 am. Stan everytime I went to the booth you were missing. I tried this morning but you were in a meeting somewhere. Jason was that you outside the Renaisance after MTUG. And finally wait till you see the ne...

Bruce1807

I had an AC fail and we didnt have the moscad temp sensor working.
12 quantros., nuke and other stuff.
The UPS said it was 135 and everything still worked but the microwave became a little flaky

Bruce1807

Most of the new features for the XTS2500 only work with B version radios wheich began shipping earlier this year.
Command board now has 8 Meg

Bruce1807

works fine on 5000 and 1500 as well as 2500

Bruce1807

Anyone looked at weather.com for the week?
It's gonna be hot, worse than Orlando last year.
104 on Wednesday!

Bruce1807

yes it can, I think it was version 8
It will just show lat long

Bruce1807

CPS is generally backwards compatible and there was even a convert function at one stage

Bruce1807

It will work but from memory you wont have the RF switch but thats about all. (I may be wrong on the switch)

Bruce1807

RLN5671A IMPRES Field programmer 175.00
No it a freestanding programmer
You use the computer just to load to the programmer.

So the answer is no.

Bruce1807

It looks like just a friendly search engine for the FCC.
That should be used with a spectrum audit.

Bruce1807

MDUG
Motorola Data Users Group

Bruce1807

try and remove the top cover on the radiovery carefully at the bottom and remove the boards and the battery contacts.
From there a bit of brute force should solve the problem.

Bruce1807

Maybe it is something to do with the equipment being teseted at high and low temperartures!!! Probably affects the sensability

Bruce1807

GP 300 etc was Yoda!

Bruce1807

Also are they both impres as there is a smart battery warning adjustment under advanced in radio waide but that tells you how early the beep starts.

Search found 1170 matches