MCS2000- Programming accessory connector

[arlojanis]

Where is the place in CPS to program the accessory pins for I/O 3, 4, and 5 ? This is a MCS2000 high power.

[tazada]

Any reply to this message? Is it possible to channel steer a MCS via these pins? PL/DPL logic?

Thanks

[motorola_otaku]

Short answer: you cannot program the accessory pin functions on a MCS2000 or channel-steer with them.

Slightly-longer answer: You can add a jumper to get true active-low COR and all the other connections are present by default (RX audio, TX audio, and PTT) for use in repeater linking, if that's what you're after.