MC2500 tone remote failure troubleshooting

This forum is for discussions regarding System Infrastructure and Related Equipment. This includes but is not limited to repeaters, base stations, consoles, voters, Voice over IP, system design and implementation, and other related topics.

Moderator: Queue Moderator

Post Reply
maxjam
Posts: 124
Joined: Fri Sep 07, 2001 4:00 pm

MC2500 tone remote failure troubleshooting

Post by maxjam »

I took a chance on 2 mc2500 units. One powers up and works great, the other just lights up and you can hear the relay pull in. After verifying the voltages were good, I swapped the bottom base with the working unit. The problem follows the top. The buttons don't light and nothing shows on the display so it appears that it isn't booting. Has somebody troubleshot a similar issue with the MC2500?

At least one is working.. sure is nice to have only 1 remote on the desk for my Cisco tone remote project!

Thanks
Post Reply

Return to “Base Stations, Repeaters, General Infrastructure”