MTR2000 COR Active during PTT

This forum is for discussions regarding System Infrastructure and Related Equipment. This includes but is not limited to repeaters, base stations, consoles, voters, Voice over IP, system design and implementation, and other related topics.

Moderator: Queue Moderator

Post Reply
ve3nsv
Posts: 291
Joined: Sat May 27, 2006 8:43 am

MTR2000 COR Active during PTT

Post by ve3nsv »

Has anybody seen this issue where any COR line on the MTR2000 goes active when the PTT line is used? I've tried PTT and COR off the J5 and J7 connector with the same results. The station is programmed as a base station.
User avatar
Vercomm
Posts: 429
Joined: Mon Apr 12, 2004 7:00 pm

Re: MTR2000 COR Active during PTT

Post by Vercomm »

In the station programming, what is you're analogue rx activation set to? Csq or csq/pl?

What station firmware does your unit have?
"Life's journey is not to arrive at the grave safely in a well preserved body, but rather to skid in sideways, totally worn out, torn up and shouting... "Holy Sh*t...what a ride!!"
ve3nsv
Posts: 291
Joined: Sat May 27, 2006 8:43 am

Re: MTR2000 COR Active during PTT

Post by ve3nsv »

Firmware is 3.02.003 and rx activation is programmed for carrier & PL.
User avatar
Vercomm
Posts: 429
Joined: Mon Apr 12, 2004 7:00 pm

Re: MTR2000 COR Active during PTT

Post by Vercomm »

There is a firmware update for your repeater...but not sure that is the issue. Are you connecting to cor on system connector j5 c02?
"Life's journey is not to arrive at the grave safely in a well preserved body, but rather to skid in sideways, totally worn out, torn up and shouting... "Holy Sh*t...what a ride!!"
ve3nsv
Posts: 291
Joined: Sat May 27, 2006 8:43 am

Re: MTR2000 COR Active during PTT

Post by ve3nsv »

Yes I have tried C02, B03 & C03 and 15 MRTI Rx Carrier* O.C. Goes to ground with properly coded carrier.
Post Reply

Return to “Base Stations, Repeaters, General Infrastructure”