Page 1 of 1
MTR2000 COR Active during PTT
Posted: Thu Apr 06, 2017 5:30 am
by ve3nsv
Has anybody seen this issue where any COR line on the MTR2000 goes active when the PTT line is used? I've tried PTT and COR off the J5 and J7 connector with the same results. The station is programmed as a base station.
Re: MTR2000 COR Active during PTT
Posted: Fri Apr 07, 2017 1:16 am
by Vercomm
In the station programming, what is you're analogue rx activation set to? Csq or csq/pl?
What station firmware does your unit have?
Re: MTR2000 COR Active during PTT
Posted: Fri Apr 07, 2017 7:32 am
by ve3nsv
Firmware is 3.02.003 and rx activation is programmed for carrier & PL.
Re: MTR2000 COR Active during PTT
Posted: Fri Apr 07, 2017 7:44 am
by Vercomm
There is a firmware update for your repeater...but not sure that is the issue. Are you connecting to cor on system connector j5 c02?
Re: MTR2000 COR Active during PTT
Posted: Fri Apr 07, 2017 9:57 am
by ve3nsv
Yes I have tried C02, B03 & C03 and 15 MRTI Rx Carrier* O.C. Goes to ground with properly coded carrier.