GTR8000 Conventional Firmware Upgrade issue
Posted: Thu Nov 23, 2017 2:26 pm
Hi all!
I come across strange issue with GTR8000 Conventional firmware upgrade. It is V1 (Gen1) hardware and I have had it working until decided to upgrade firmware. Originally, it was CONVBR_R07.DX.069_V3, but I loaded CONVBR_R07.107_V3 into. All operations were successful, but It can't read it via CSS. It reaches 33% and cannot move further. In addition, red alarm indicators blinks synchronously at the both radio modules.
I can connect to it via SWDL, check errors (there are no errors), can get versions, can upgrade, etc. But can't read and write via CSS.
Bank2 become CONVBR_R07.107_V3, but Bank1 remained CONVBR_R07.DX.069_V3. After that I upgraded Bank1 manually to CONVBR_R07.107_V3. No changes.
I tried different PC, radio restart, but no luck.
Blinking red alarm means Impaired, but many many of Motorola G-series manuals doesn't have any detailed information about this status. Only some very brief info that device is not fully operational due to internal or external causes. Some corrective actions must be taken. And nothing else.
Any ideas? I have only two:
1. Fresh firmware and V1 (Gen1) radio
2. BX vs CX vs DX firmware - I have no ideas what these suffixes mean
Any help will be appreciated!
I come across strange issue with GTR8000 Conventional firmware upgrade. It is V1 (Gen1) hardware and I have had it working until decided to upgrade firmware. Originally, it was CONVBR_R07.DX.069_V3, but I loaded CONVBR_R07.107_V3 into. All operations were successful, but It can't read it via CSS. It reaches 33% and cannot move further. In addition, red alarm indicators blinks synchronously at the both radio modules.
I can connect to it via SWDL, check errors (there are no errors), can get versions, can upgrade, etc. But can't read and write via CSS.
Bank2 become CONVBR_R07.107_V3, but Bank1 remained CONVBR_R07.DX.069_V3. After that I upgraded Bank1 manually to CONVBR_R07.107_V3. No changes.
I tried different PC, radio restart, but no luck.
Blinking red alarm means Impaired, but many many of Motorola G-series manuals doesn't have any detailed information about this status. Only some very brief info that device is not fully operational due to internal or external causes. Some corrective actions must be taken. And nothing else.
Any ideas? I have only two:
1. Fresh firmware and V1 (Gen1) radio
2. BX vs CX vs DX firmware - I have no ideas what these suffixes mean
Any help will be appreciated!