MIP5000 MDC ID Problem

[caprice96]

I don't know if anyone has worked with the MIP5000 but if you can offer any insight to my question it will be greatly appreciated. So at work we have a 2 channel UHF repeater system and we are using the MIP5000 as a console for certain people to talk to others in the field. All of our radios have MDC1200 enable with a trailing ID. My problem is that the MIP5000 interface will not decode the ID with an alias or even the raw ID. The repeater is passing the data because I can see the ID decoded on my radio. I can also hear the MDC burst through my computer speakers. Any ideas?

Thanks

[RKG]

MDC decoding is timing sensitive. Your console decoder should be programmed with the same parameters as the subscriber equipment is using.

The MIP5000 is a VOIP system, and IP latency may have something to do with it. Note the suggestions in the literature re: "dedicated LAN/WAN connection on a secure, non-congested QoS enabled network."