Minitor 2 amplified charger, relay help

This forum is focused on discussing Digital and Voice paging equipment, protocol's, infrastructure, and Motorola specific hardware used. Please refrain from discussing different ways to monitor the digital paging systems due to the legalities of such.

Moderator: Queue Moderator

Post Reply
elkgrovefire215
New User
Posts: 1
Joined: Sun Apr 28, 2013 9:35 am

Minitor 2 amplified charger, relay help

Post by elkgrovefire215 »

Sorry in advance for another question on this topic. But here it is.

I have a minitor 2 amp charger, a 12 volt light and I'm trying to wire it up so that when alerted the light will turn on. I've seen a lot of information on this but I am not very good with electronics.
Does anyone have a schematic or pictures of how the din pin is wired and connected to the light?
Thanks in advance. JK
kd5wfy
New User
Posts: 24
Joined: Wed Oct 03, 2007 3:48 pm

Re: Minitor 2 amplified charger, relay help

Post by kd5wfy »

Maybe this will help

http://www.batlabs.com/minitor.html

You can't power a light directly off the internal relay. You will need to use a low voltage power supply to feed another relay to power any kind of light. I have a set up at my house for when my volunteer dept gets paged out it turns a lamp on in my room till I press the reset button on the amp charger.

Hope this helps some
Post Reply

Return to “Motorola Digital and Voice Paging”