Minitor VI(6)

This forum is focused on discussing Digital and Voice paging equipment, protocol's, infrastructure, and Motorola specific hardware used. Please refrain from discussing different ways to monitor the digital paging systems due to the legalities of such.

Moderator: Queue Moderator

Post Reply
Jtsou
New User
Posts: 10
Joined: Thu Jun 23, 2011 7:43 pm

Minitor VI(6)

Post by Jtsou »

I have read old posts about this however I am not able to find much information.

Does anyone have the programming pinout for the Minitor VI pager? I know in the past it was fairly easy to rig up a programming interface for the 3, 4, and 5 pagers. I was wondering if anyone has the pinout for programming these pagers. Initially programming cradles were rather cheap however now I am unable to find one that is much short of $100.

Upon reading it seems the 6 uses the prolific USB/TTL signals so it seems to have the same connections as the other pagers did.

Also has anyone figured out the Engineering mode for the PPS?

Thanks.
User avatar
SteveC0625
Posts: 467
Joined: Sat Jan 01, 2011 9:46 am
What radios do you own?: CDM's, CP's, CM's, and more

Re: Minitor VI(6)

Post by SteveC0625 »

Jtsou wrote:Also has anyone figured out the Engineering mode for the PPS?
To date and to the best of my knowledge, there is no Engineering Mode for the Minitor VI PPS.

"If" it even exists, it is a very closely guarded secret. I have found no evidence of it on the net.
Post Reply

Return to “Motorola Digital and Voice Paging”