IFR 2975 Issue ?

[Jim53]

I am trying a simple task of tuning my IFR 2975 to pick up an FM radio station. I can see the signal being transmitted at 101.5 mHz but cannot get it to demodulate to give me audio out of the speaker. Will kick myself I am sure but what am I missing? I do get the carrier noise but no audio.

using antenna port
RX set to FM
demod audio
generators off
FM output off


Thanks ahead of time

[fineshot1]

Typically FM radio stations transmit about 100khz wide and the typical
FM setting in a service monitor is about 5Khz so you are most likely
not getting enough of the modulation to decode.

[Jim53]

Thanks to fineshot1 appreciate the response.

[fineshot1]

No problem - you are welcome but i must stress that i am guesstimating in my response.