I am trying a simple task of tuning my IFR 2975 to pick up an FM radio station. I can see the signal being transmitted at 101.5 mHz but cannot get it to demodulate to give me audio out of the speaker. Will kick myself I am sure but what am I missing? I do get the carrier noise but no audio.
using antenna port
RX set to FM
demod audio
generators off
FM output off
Thanks ahead of time
IFR 2975 Issue ?
Moderator: Queue Moderator
Re: IFR 2975 Issue ?
Typically FM radio stations transmit about 100khz wide and the typical
FM setting in a service monitor is about 5Khz so you are most likely
not getting enough of the modulation to decode.
FM setting in a service monitor is about 5Khz so you are most likely
not getting enough of the modulation to decode.
fineshot1
NJ USA
NJ USA
Re: IFR 2975 Issue ?
Thanks to fineshot1 appreciate the response.
Re: IFR 2975 Issue ?
No problem - you are welcome but i must stress that i am guesstimating in my response.
fineshot1
NJ USA
NJ USA