CDM in Zone 2 But Defaults to #1 Freq. in Zone 1 Scan List

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
ten13
Posts: 27
Joined: Mon Nov 24, 2003 6:32 am

CDM in Zone 2 But Defaults to #1 Freq. in Zone 1 Scan List

Post by ten13 »

I set up my 1250 with a 2nd Zone, along with setting up a Scan List 2 for Zone 2.

When in Scan mode in Zone 2, it prioritizes the frequency in the #1 position in Scan List 1, Zone 1.

All Zone 2 channels have Scan List 2 selected, and the #1 position in Zone 1 has Scan List 1 selected.

The frequency in that Zone 1 is not on Zone 2.

What S/W box didn't I check, or do I have one that shouldn't be checked?

Thanks!
ten13
Posts: 27
Joined: Mon Nov 24, 2003 6:32 am

Re: CDM in Zone 2 But Defaults to #1 Freq. in Zone 1 Scan List

Post by ten13 »

DISREGARD....

Stupid programming mistake with a couple of channels.

Condition corrected....
Post Reply

Return to “Radio Programming”