Batboard

I have an APX6500 that is a remote mount dual O5 head 700mhz.

The O5 head is installed in a Tahoe center console next to a UHF PM400 and a VHF CM300. The 05 head's speaker is at the back of the console on the floor pointed up toward the ceiling.

Until recently, the CM300 was rarely if ever used. Now the CM300 is being used more more and more. The issue we are having is when the CM300 is receiving, there is a lot of static and interference when the APX is also active and receiving traffic. When the CM300 is receiving and the APX is not, no static.

I created the same set up on a desktop. Same thing. Any ideas?

Thanks in advance

Its more plausible the O5 control head is causing this condition than the speaker.

Can you provide the frequency for the CM300

Next course I would take is to separate the radios to see how far apart they need to be to clear up the condition and both be rx'ing.

There are known frequency spurs from the controllers for the control heads.

A video of this would be great as well

CoM

the VHF is mostly receiving on 155.47500.

i will get a video

Thanks!