Page 1 of 1

Systems Saber refusing to scan

Posted: Sat Apr 29, 2017 12:50 pm
by Radio Intelligence Agency
Hi guys,

I hope there´s still one or more folks around who remember some details about the Systems Saber when it comes to programming.
For some reason I seem to be unable to figure out why my WHCA Systems Sabers have a problem with the scan funktion. They do scan but with open squelch on each personality in the scan list. When scan is activated the radio simply stops on each channel and squelch noice is present on every channel in the list. When scan is deactivated the radio then acts normal again. I have added only one single scan list in this Codeplug. The channels in the list are both pl and csq channels.

I´ve been away from these rather Oldschool thiggies for at least ten years so plz excuse me being a little rusty.

What could I be doing wrong in the RSS?