HT1250 CPS error

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
RT145
New User
Posts: 12
Joined: Tue Jan 15, 2013 6:20 am

HT1250 CPS error

Post by RT145 »

So this is a new one..

I have been trying to program a group of HT1250s that I have. When attempting to read the radio I get the following error:

"80040154: Couldn't createinstance on the device after getting UUID"

CPS version is R06.12.02 and the models are all AAH25SDF9AA5AN.

Anyone have any idea what this might be? I've never seen this error before. I also have an older version of CPS as well but that says unsupported model. The radios state that the software version is R05.14.00.
JPOPatents
Posts: 307
Joined: Thu Sep 25, 2008 7:36 pm

Re: HT1250 CPS error

Post by JPOPatents »

Your CPS version is either too old, or you have corrupted CPS/bad installation. There are several posts on the board about that error.
-John
JPOPatents
Posts: 307
Joined: Thu Sep 25, 2008 7:36 pm

Re: HT1250 CPS error

Post by JPOPatents »

You could also have a problem with your RIB or, if you are using an aftermarket "ribless" programming cable you could have a problem with the cable or drivers.
-John
Shuttle
Posts: 34
Joined: Fri Feb 13, 2009 2:01 pm

Re: HT1250 CPS error

Post by Shuttle »

What operating system are you using?
Serial port, real or usb-rs232?
RT145
New User
Posts: 12
Joined: Tue Jan 15, 2013 6:20 am

Re: HT1250 CPS error

Post by RT145 »

It is an aftermarket ribless cable. What's wierd though is that one of the radios read/programmed fine but the rest are having issues.
Post Reply

Return to “Radio Programming”