800MHz Maxtrac to 902 problems
Posted: Sun Jun 05, 2016 4:10 pm
Hey All,
I am having some trouble with an 800MHz maxtrac configured as a 900MHz receiver. The radio is a model D45MWA5GB7AK, HLF9122A RF board, HLN9313B Logic board and HLN9435D Firmware. This radio came to me already programmed up for a 902 frequency and was operation until I decided to mess with it. As best as I can tell, it was set up was a Maxtrac 840 radio. I am pretty sure that it also had a trunking channel in it, because I had CH1 and then 1A. I noticed that when I went into the accessory connector menu to set it up for "General I/O", that that option wasn't available. I decided to blank to logic board and try to re-initialize it as a more feature-rich board. After my attempt, I started getting a quick 300Hz- or so beep, then a 500Hz constant tone. I thought once I found the right combination of options on the "Board Replacement" menu that I would be fine. I tried putting it back to what I think it was originally and then spent about two hours trying different selections with no luck.
Anybody have any ideas or is this one a brick?
Thanks,
Jordan
I am having some trouble with an 800MHz maxtrac configured as a 900MHz receiver. The radio is a model D45MWA5GB7AK, HLF9122A RF board, HLN9313B Logic board and HLN9435D Firmware. This radio came to me already programmed up for a 902 frequency and was operation until I decided to mess with it. As best as I can tell, it was set up was a Maxtrac 840 radio. I am pretty sure that it also had a trunking channel in it, because I had CH1 and then 1A. I noticed that when I went into the accessory connector menu to set it up for "General I/O", that that option wasn't available. I decided to blank to logic board and try to re-initialize it as a more feature-rich board. After my attempt, I started getting a quick 300Hz- or so beep, then a 500Hz constant tone. I thought once I found the right combination of options on the "Board Replacement" menu that I would be fine. I tried putting it back to what I think it was originally and then spent about two hours trying different selections with no luck.
Anybody have any ideas or is this one a brick?
Thanks,
Jordan