Users may not create topics, posts, or private messages containing or relating to the following material (especially pertaining to Motorola copyrighted software, unless you want Motorola to come along and shut this site down):

  • Listing for sale or trade of, or links to sites offering for sale or trade of, or giving away, Radio
    Service Software (RSS) or Customer Programming Software (CPS)
  • Profanity, pornography, defamation, or slanderous remarks directed towards any individual or entity
  • Commercial advertising (except in the Batboard Vendors forum, as approved by the Admin/Mod Staff)
  • Any other items which may be deemed as offensive

If any topics, posts, or private messages containing or relating to the aforementioned material are brought to the attention of the Admin/Mod Staff, they will be deleted.

Additional FAQ items appear here in Forum Rules. Please review them for posting guidelines and further clarification.

Low Power MaxTrac 900

This forum is for the discussions targeted at converting various models of Motorola equipment to operate in the 900MHz Amateur Band.

Moderator: Queue Moderator

Jonathan KC8RYW
Posts: 1747
Joined: Fri Dec 28, 2001 4:00 pm

Low Power MaxTrac 900

Postby Jonathan KC8RYW » Tue Jul 22, 2008 10:21 pm

I'm looking to make the MaxTrac 900 12W into something more reliable with lower power (without worrying about a PA burning up) for a repeater transmitter.

The VHF and UHF LPI Maxtracs just lack the last section of the PA.

But the Maxtrac 900 PA has the last three sections together in the same RF hybrid module.

The MaxTrac 900 RF board outputs about 200 mW according to the service manual.

How about just bypassing the RF module (MHW820-3???) at the output of Q3001 (MRF599??) on the 15W PA board?

What about just bypassing Q3001 and feeding the RF direct from the RF board to the RF module (5180110E03)?
73 DE KC8RYW
Random Motorola Part Number:
SYN1894B - V3m Sprint-branded Battery Cover

User avatar
kcbooboo
Batboard $upporter
Posts: 2087
Joined: Wed May 01, 2002 9:03 am

Re: Low Power MaxTrac 900

Postby kcbooboo » Thu Jul 24, 2008 2:30 am

The Spectra PA is very similar to the MaxTrac PA in that they use a driver transistor to feed an RF brick. The Spectra service manual says that just about any point you'd use to troubleshoot, is 50 ohms. They tell you what to disconnect and measure to check each stage.

I don't think that bypassing the driver transistor will make the RF brick put out lower power. It's a class-C device and needs some minimum amount of drive before it will produce any power.

Probably the simplest way would be to disconnect the RF brick and use the driver output to feed your external PA. Adjusting the power level may be a problem, because the radios normally fiddle with a control voltage in the RF brick to do that.

I don't know what mechanism the 2-4w MaxTracs use to control RF power in the PA. I've never looked into it.

Bob M.


Return to “Converting Motorola Equipment to 900MHz Amateur”

Who is online

Users browsing this forum: No registered users and 3 guests