Moderator: Queue Moderator
6 posts • Page 1 of 1
purchased a ucm/ keypad for my xts2500. it has a few algos ( a lot) and when i plug in my t3011dx radio goes to keyload mode, try loading a few keys and i get an error on the kvl. Unlike my 2500, all my xts5000s load fine. CPS settings for the 2500 are identical to the xts5000s. what could i be doing wrong?
Is the "Enable PID Key management" checkbox enabled?
just did that still getting fail on the kvlMattSR wrote:Is the "Enable PID Key management" checkbox enabled?
Is the radio going into the "KEYLOAD" mode on the screen when you hook it up to the KVL?
- Posts: 2685
- Joined: Tue Oct 30, 2001 4:00 pm
- What radios do you own?: APX / Astro 25 / Harris
Can't load keys until keyloading or keyload is displayed on any radio. If that isn't displayed there is either a cable problem,housing problem or the UCM itself is bad.
"Some men just don't know their limitations"