Users may not create topics, posts, or private messages containing or relating to the following material (especially pertaining to Motorola copyrighted software, unless you want Motorola to come along and shut this site down):

  • Listing for sale or trade of, or links to sites offering for sale or trade of, or giving away, Radio
    Service Software (RSS) or Customer Programming Software (CPS)
  • Profanity, pornography, defamation, or slanderous remarks directed towards any individual or entity
  • Commercial advertising (except in the Batboard Vendors forum, as approved by the Admin/Mod Staff)
  • Any other items which may be deemed as offensive

If any topics, posts, or private messages containing or relating to the aforementioned material are brought to the attention of the Admin/Mod Staff, they will be deleted.

Additional FAQ items appear here in Forum Rules. Please review them for posting guidelines and further clarification.

MC2100 aka MCS2000 mobile set

This forum is dedicated to helping people with questions about installing radio equipment in vehicles. This can include antenna installs, electrical wiring questions/problems, and mounting systems. Pictures of installs are welcome.

Note: Discussions regarding lighting, sirens, and other equipment now has its own forum in the 'off-topic' section below.

Moderator: Queue Moderator

PE1PMO
New User
Posts: 1
Joined: Thu Oct 05, 2017 4:49 am

MC2100 aka MCS2000 mobile set

Postby PE1PMO » Thu Oct 05, 2017 4:57 am

Goodmorning !

Looking for an answer to a question on a problem with my Motorola MC2100 (MCS2000 lookalike) I saw your forum ! The problem I have here is that when I put on voltage on the 12 V backside-connector the set immedatley powers up, so when mounted in the car and going to "ignition" the MC2100 goes on the same time.
Is there a solution to solve that, that it stays off ? Had a look at the acc connector, there is a pin called Ignition, what is the function of it ?
Cannot find anything about in on the Internet, or was looking at the wrong place, hi.
Have several MC2100 VHF / UHF, from former Firebrigade and MOD, and like to make it function normally.
Or do I have to put a switch in between the powercord ? Programming isn't the problem, I have sw and hw.

Tnx in advance,

73, de Jan PE1PMO, Netherlands. (also PE1PMO@VERON.NL)

fineshot1
Posts: 908
Joined: Wed Oct 12, 2005 5:13 am

Re: MC2100 aka MCS2000 mobile set

Postby fineshot1 » Sat Oct 07, 2017 10:07 am

The public safety common way to to hook up power to an MCS2000 is to have constant +12V
to the main power cord connection and the Accessory connector pin 15 (ignition) to a +12V
ignition source which should power up the radio. I always setup the above Accessory connector
in CPS programming software to be "Soft Power Off". In this way the radio power up and down
follows the ignition +12V and also allows the operator to be able to overide powerup the ignition
with the push button IE: Radio is off and pushing the button turns on the radio - like the officer
is off to the side of the road with the engine off.

I recommend you go through both the physical accessory connections and the cps settings and make
sure physical acc pins 9 and 10 are shorted together - if not the radio will power up and send an emergency
data burst as soon as +12V is turned on to the main power connection to whatever radio system it was originally programmed for.

http://www.batlabs.com/gm900.html
fineshot1
NJ USA


Return to “Vehicle Radio Installs”

Who is online

Users browsing this forum: No registered users and 2 guests