Batboard

I have recently transitioned to a 2013 Ford Expedition Special Service package vehicle and wondered if anyone has a factory wiring detail that shows where to cut and insert the headlight flasher and tailback flasher into the system. I am surprised that Sound Off, that makes the flashers we use, doesn't have diagrams specific to the vehicles.

Any help appreciated.

Mike

Did you look on Ford's up fitters web pages?

Thank you Steve.

Too bad they do not have something like that for a 2012 Jeep Liberty Sport.......

Thank you Steve. It doesn't appear that the information is specific to the Expedition since if I am not mistaken, the Utility Interceptor would be the Explorer....I will look around but very good info regardless.

Mike

mhodgson wrote:Thank you Steve. It doesn't appear that the information is specific to the Expedition since if I am not mistaken, the Utility Interceptor would be the Explorer....I will look around but very good info regardless.

Mike,

There should be an upfitters guide for the SSV Expedition and/or the F150 somewhere on that Ford site. It took me some poking around, but I found all kinds of guides for my F250 in that same section of the Ford Fleet website.

There is no upfitter guide for the Special service Expedition. The headlight flasher wire is just done at the highbeam wire behind the headlight. The tail light flasher is done usually in the rear behind the interior trim close to the tail lights. Sound off inc has all the exact colors.