Page 1 of 1

Saber Convertacom Power wiring / plug question

Posted: Mon Nov 27, 2006 11:10 am
by motosaber
I purchased saber III and a convertacom NTN5487B. Am having a local radio shop program the radio for 2 meters later this week; however, there was no power cable with the convertacom. I either need to locate one or make one up. Any help on wiring diagram or 4 pole plug wiring would be appreciated. Thanks

Posted: Mon Nov 27, 2006 11:49 am
by FireCpt809
Power

Red + Power
Black - Power
Yellow Ignition Sense (disables battery charger)
Green Headlight Sense (turns on panel lights in MVA)


http://www.batlabs.com/saber.html

Power Plug configuration

Posted: Mon Nov 27, 2006 2:33 pm
by motosaber
looking at the back of the convertacom are the pins for the power plug Left to Right = Red Black Yellow Green, basically is the extreme left pin = red? Thanks

Posted: Mon Nov 27, 2006 8:46 pm
by techie
For the Astro Saber AVA NTN7227C, the wiring is like so:

The connector should have numbers on the shell.

1- black
2- green
3- yellow
4- red

this is with the female (cable end) pins up/wires down, with the flat side facing you, and the angled cuts away from you. numbering is left->right.1234.

The is the same connector used for hard disks, etc..

don't forget fuses. 5A on each of the red, green, and yellow leads.

As a sanity check, dc ground and antenna ground will have continuity.

Thanks

Posted: Tue Nov 28, 2006 5:29 pm
by motosaber
I really appreciate both responses. I am new to this forum and have gleaned a lot of good information already. Again thanks for taking time to respond with your information.

Re: Saber Convertacom Power wiring / plug question

Posted: Wed Jul 11, 2007 7:29 am
by toyradios
Does anyone know how to disable the back-light on the Saber Convertacom.

Power
Red + Power
Black - Power
Yellow Ignition Sense (disables battery charger)
Green Headlight Sense (turns on panel lights in MVA)

I'm looking to use a spare convertacom as "lockable" Saber battery charger, but don't want the green back-light on to attract attention.

The green wire on mines is not hooked-up and the back-light is always on.

Thanks
Bill

Re: Saber Convertacom Power wiring / plug question

Posted: Fri Aug 03, 2007 7:37 am
by firebug24
Hi all

I have a Motorola AVA model NTN7227C and like to know if this will work correctly with the regular Sabers & System Sabers ???? The front of this AVA says ASTRO !!!!!
thanks
steve w :o

Re: Saber Convertacom Power wiring / plug question

Posted: Fri Aug 03, 2007 8:56 am
by Tom in D.C.
It's all here, middle of the page:

http://www.batlabs.com/astrosab.html

Regular Saber and Astro Saber work in the AVA.
Astro Saber won't work in an SVA.