OK... I'm stumped...
How do you set the squelch level on an XTS3000? I am working on a UHF model II with ASTRO ver. 8.0 if that helps. Under the service (F2) menu, I don't see any squelch alignment functions.
I have found, however, the fine tune settings in each individual personality screens.
What gives?
Thanks in advance,
Yosh
KD6PXE
WPOL560
XTS3000 Squelch Alignment
Moderator: Queue Moderator
Yosh,
You have to adjust it on a personnality by personality basis. Get into to the conventional personality screen and select F9 (more options) and about 3/4 of the way down on the left side you will see SQUELCH (FINE TUNE) lower this number to open squelch more and increase the number to close squelch more, actually it won't give enough range to actually open the squelch and hear background noise but you can get down to about 6 or 7 dB Sinad and above 18 db sinad where the squelch opens.
Also remember you need to do this for each personality, it's kind of a pain but if you keep the cursor on the SQUELCH (FINE TUNE) selection and hit F4 to cycle thru personalities it goes fast.
Mike
You have to adjust it on a personnality by personality basis. Get into to the conventional personality screen and select F9 (more options) and about 3/4 of the way down on the left side you will see SQUELCH (FINE TUNE) lower this number to open squelch more and increase the number to close squelch more, actually it won't give enough range to actually open the squelch and hear background noise but you can get down to about 6 or 7 dB Sinad and above 18 db sinad where the squelch opens.
Also remember you need to do this for each personality, it's kind of a pain but if you keep the cursor on the SQUELCH (FINE TUNE) selection and hit F4 to cycle thru personalities it goes fast.
Mike