Keyloader upgrade?

[Dale Earnhardt]

Hey does any one know how much to upgrade a CX to a DX model?
got a DVP-XL loader here, wanna to get it up for DX

I remember there was a posting long time ago about how to install the upgrade too, but not sure what post was that under.

[RESCUE161]

It's just a single chip going from CX to DX.

I did a DES (3011CX) a while back. It was very easy and it still works like a champ. It only ran me about $100.00 or so for the chip.

I'm not sure if the DVP would use the same chip as the DES. If it doesn't, you may have a hard time trying to find one that is reasonably priced. There's a ton more of DES stuff floating around, hence the cheaper price.

Good luck!

[Dale Earnhardt]

Yeahh, hopefully its not expensive.... thanks for the info.

[Dale Earnhardt]

ohhh do any of you guys know if a BX chip upgrade to a DX will work for a CX model???

[mx2000]

Simple answer -- NO,

The CX upgrade requires replacing two IC's, whereas a BX requires only one.

[Dale Earnhardt]

Ahhh ok, THanks for that info

[clavo]

That other chip is just a memory chip (8 pin socketed IC if i remember correct) and costs a few bucks.

Simple answer -- NO,

The CX upgrade requires replacing two IC's, whereas a BX requires only one.

[jmr061]

BX to DX and CX to DX should be exactly the same. BX includes a higher memory eeprom that stores the actual key data. Since the CX model already has this higher memory eeprom for the key data the CX to DX conversion only comes with the ROM eprom which in theory would be exactly then same in BX or CX to DX upgrade. After all you are completely changing the ROM eprom, not changing its programming. So why would two ROM chips that end up making the unit a DX be different??

Jason

[Woody_99]

.
Another question to toss onto this thread....

Can a 3020AX be upgraded to do DES/XL in any fashion?
If so, how far can it be upgraded, at what cost?
thanks,