Displaying Flashcode on a AstroSaber II

This forum is dedicated to discussions pertaining specifically to the Motorola ASTRO line of radios (those that use VSELP/IMBE/AMBE), including using digital modulation, digital programming, FlashPort upgrades, etc. If you have general questions please use the General or Programming forums.

Moderator: Queue Moderator

Post Reply
User avatar
Johnno
Batboard $upporter
Posts: 86
Joined: Fri Oct 18, 2002 7:09 pm
What radios do you own?: XTL2.5K,XTS2.5k, P25 stuff....

Displaying Flashcode on a AstroSaber II

Post by Johnno »

I know it is possible to bring up the flashcode on the display of a AstroSaberII. Is there a specific key that needs to be held down during power on? The display will read flascd xxxxxx-xxxxxx-x, or similar. Any suggestions. Thank you. John.
Top
tvsjr
Posts: 4118
Joined: Fri Nov 28, 2003 9:46 am

Post by tvsjr »

Immediately after power-on, press the rear wrap button five times in rapid succession. The display will display SERVICE, then spit out the firmware revisions, EMC data, flashcodes, etc.
Last edited by tvsjr on Sun Apr 10, 2005 10:05 pm, edited 1 time in total.
Top
User avatar
Fuel4300
Batboard $upporter
Posts: 563
Joined: Wed Jun 11, 2003 12:36 am

Post by Fuel4300 »

Its the rear one with two dots.


Mike
Top
Post Reply

Return to “Legacy Batboard Motorola ASTRO (VSELP/IMBE/AMBE) Equipment Forum”