PRO9150 MDC

J_L_COHEN · Post by **J_L_COHEN** » Sun May 22, 2005 1:10 am

Hi guys this one has me stumped, I have looked at all the posts in the search, but I can't seem to find a correct answer so I am asking the experts, I am trying to set up mdc from a gp300 to a pro9150, I have set up numorus ht1250's and they work fine, but this radio just won't decode I have kept the same settings in both radios just changed the id #, when the transmiting radio keys I can hear the mdc, but no id # comes up, so i did some changes to both radios but no luck, I even created a seperate freq on both radios and a new mdc for both but I cannot get the 9150 to decode. could it be the 9150 is unable to decode a mdc or does the 4 lines of info on the 9150 take up too much room and leaves no room for the decode.
Jeffrey

Crimestopper · Post by **Crimestopper** » Sun May 22, 2005 8:42 pm

the 9150 is the same as the 1550 except it won't do LTR or passport. Check your programming again, it can and has been done on the PRO9150

Post by **wavetar** » Mon May 23, 2005 5:30 am

Are you selecting MDC as the rx signalling system in the conventional personality? If you don't, it'll do exactly what you're describing.

Todd