Hi all,
I've got an XTL5000 operating on a simulcast Astro SmartZone system that won't transmit. I didn't program it, the county did, so there is a chance of a programming error on their part.
Anyway, the radio receives fine, and transmits fine on conventional channels - just won't work on the trunked system.
When keyed up, the TX light flashes for a second, but then I get the dreaded BONK sound instead of the channel grant tone - no error messages are shown on the display.
Could it be that the radio ID was never activated in the SmartZone controller, and the system is denying access because it thinks the radio is not valid? If this is the case, why would it not cause problems every time the radio affiliates on power up/mode change?
Thanks - I'll probably be taking it into the shop soon anyway, but just thought I'd ask here to see what it might be.
Charlie
XTL5000 Won't Transmit
Moderator: Queue Moderator
- fireradio
- Batboard $upporter
- Posts: 606
- Joined: Sat Sep 15, 2001 4:00 pm
- What radios do you own?: Various APX series
XTL5000 Won't Transmit
OSS
"Keeping public safety on the air..."
"Keeping public safety on the air..."
- N4DES
- was KS4VT
- Posts: 1234
- Joined: Thu Dec 25, 2003 7:59 am
- What radios do you own?: APX,XTS2500,XTL2500,XTL1500
Sounds like the ID was never turned on or the ID was set as to not
allow the radio to transmit. If it flashes once it is a safe bet that it's the latter of the two. If the ID wasn't programmed in the the system typlicially the radio will usually make several attempts to affiliate and the LED will flash multiple times.
allow the radio to transmit. If it flashes once it is a safe bet that it's the latter of the two. If the ID wasn't programmed in the the system typlicially the radio will usually make several attempts to affiliate and the LED will flash multiple times.
- N4DES
- was KS4VT
- Posts: 1234
- Joined: Thu Dec 25, 2003 7:59 am
- What radios do you own?: APX,XTS2500,XTL2500,XTL1500
Not that I have seen. Here is an example of a radio that doesn't have the ID turned on in the system and programmed to affiliate. It usually does it 4 or 5 times every 2 seconds before it finally gives up.
I755841 2005-07-08 13:00:43.100 64 Requester subs record not available
I755841 2005-07-08 13:00:45.600 64 Requester subs record not available
I755841 2005-07-08 13:00:46.400 64 Requester subs record not available
I755841 2005-07-08 13:00:48.000 64 Requester subs record not available
I755841 2005-07-08 13:00:43.100 64 Requester subs record not available
I755841 2005-07-08 13:00:45.600 64 Requester subs record not available
I755841 2005-07-08 13:00:46.400 64 Requester subs record not available
I755841 2005-07-08 13:00:48.000 64 Requester subs record not available
So, the ID was not in the system at all or was disabled? The symptom you had was one flash on affiliation?fireradio wrote:Thanks for the replies - found out today that the ID wasn't activated in the system - working now!
Charlie
This is in line with what I've seen on SZ4.1 systems that a radio not in the system will only send one affiliation, not continuous.
George