Programming an XTS5000

flashport · Post by **flashport** » Tue Nov 01, 2005 4:30 am

I have an XTS5000 Model III UHF 450-527Mhz unit and i was looking to buy the original /\/\ programming equipment and software and i was wondering if the USB cable would be a better option to the RS232 lead or do they both work just as well as each other on these radios.

Regards

RocketNJ · Post by **RocketNJ** » Tue Nov 01, 2005 4:50 am

The USB cable works fine and programs the radio quicker (helpful if you've got a loaded archive). Also if you ever do any Flash upgrades or firmware refreshes the USB cable is faster.

Last, a lot of new smaller laptops are eliminating serial ports so the USB cable would be a good choice if you are ever contemplating upgrading your laptop.

George

MikeOxlong · Post by **MikeOxlong** » Tue Nov 01, 2005 8:35 am

AFAIK, my laptop only supports USB1. Will I still be able to program using the USB cable or should I order the serial cable?

boylo · Post by **boylo** » Tue Nov 01, 2005 1:53 pm

Mike,
USB 1 works fine using my Dell C840 and as George said it is way quicker than using the serial port.

MikeOxlong · Post by **MikeOxlong** » Tue Nov 01, 2005 4:24 pm

Thanks, I think I'll go with the usb cable then.