Err...what would keep causing a fail loading a key? (DVP)

poser · Post by **poser** » Fri Feb 17, 2006 6:18 pm

I'm using a DVP XL loader and using 1234 1234 1234 1112 as a test key with 0001 as an ID and when I load it into a saber II with a DVP module, I get a bunch of static from the speaker, then fail. Any help?

jmr061 · Post by **jmr061** » Fri Feb 17, 2006 10:23 pm

DVP and DVP XL are NOT the same. DVP XL will load a DVP XL not a DVP module. DVP will load a DVP not a DVP XL module.

Jason

poser · Post by **poser** » Sat Feb 18, 2006 12:01 pm

Even if I don't use the hexadecimal keys? 8-F?

jmr061 · Post by **jmr061** » Sat Feb 18, 2006 12:14 pm

They are DIFFERENT. I think I saw a DVP keyloader on Ebay the other day. Bidding was at $75 then.

Jason

poser · Post by **poser** » Sat Feb 18, 2006 5:42 pm

Thank you! I'll try to win it. Also, do I need to turn off the PL tones in the radio program or will turning on the securenet automatically do it?

mostar · Post by **mostar** » Sun Feb 19, 2006 3:13 pm

you do not need to do anything with PL - tones will be fine when operating clear, and will be ignored when you switch to secure.

poser · Post by **poser** » Sun Feb 19, 2006 6:01 pm

Thanks! So all transmissions on the freq will go through?

K8TEK · Post by **K8TEK** » Mon Feb 20, 2006 12:00 pm

Yes, as long as both radios are using the same algorithm and have matching keys.

poser · Post by **poser** » Mon Feb 20, 2006 1:04 pm

Err..I found out the problem..they weren't DVP modules, they're NTN5833A, meaning DES modules..Thanks