XTS300 ID Display

GEMOTO · Post by **GEMOTO** » Thu May 25, 2006 5:14 pm

I have a model 3 XTS3000 Flash: 500008-000400-7, R7.13.00 and DSP 8.02.06.

I have played with all of the timing settings under the PTT ID display screen in the CPS but can not make the ID stay up for more that 1/2 second when someone sends a post ID. If they send a pre-ID it works fine.

Does anyone have any ideas?

Thanks,

jmr061 · Post by **jmr061** » Thu May 25, 2006 6:10 pm

Change the DOS coast to ZERO.

Jason

Post by Pj » Thu May 25, 2006 6:22 pm

Its also carrier dependant. Obviously with pre, as long as the radio is RX'ing a signal, it will stay the entire time.

As soon as the signal drops, the ID goes pretty quick.

GEMOTO · Post by **GEMOTO** » Thu May 25, 2006 7:09 pm

Thanks Jason that was it.

PJ, usually if you set the end of voice timer the ID will stay even after the carrier has dropped.

Post by Pj » Thu May 25, 2006 9:36 pm

Yeah, I had one radio (forget the firmware) that would drop no matter what the EOT was set to. Looking back at one of my other posts, looks like it was a 7.x verison that did it which has since been corrected.