01/92 error code

eps0813 · Post by **eps0813** » Thu Jun 08, 2006 6:07 pm

Radio was working fine until dog hit power cord during programming. Now all i get is 01/92. Webpage says Reprogram Codeplug. I have a couple that i saved but it will not establish a connection from Comp. to radio. Tried cloning and get the ame thing. Keep getting an error of something along thelines of ececc: couldnt make conection stream or something of that nature.

XTS 300 UHF Model II 403-470
Model :2000466189
Codeplug Version:12
Running CPS Version 3.0

SZ$DEF · Post by **SZ$DEF** » Thu Jun 08, 2006 6:37 pm

Try the simple things first - is the battery on your radio charged fully? How about the battery in your RIB? Is it fresh?

Dale Earnhardt · Post by **Dale Earnhardt** » Thu Jun 08, 2006 8:42 pm

if am right doesn't Fail 01/92 mean the radio is abrick now, its been awhile since I looked in to it. I get that ever so often if I screw up and the laptop battery dies lol.....because am still under 9.5 dos, bear with me...... all I do is just Hit F8 for programming while turning on the radio the same time...... you have to do this a few time to get it at the right timing during Self test if I remember right. After that your radio should be good to go again.

eps0813 · Post by **eps0813** » Sat Jun 10, 2006 5:19 am

tried both with no luck ?????

jmr061 · Post by **jmr061** » Sun Jun 11, 2006 3:48 pm

You may have to use lab to push the archive or s-rec.

Jason

eps0813 · Post by **eps0813** » Sun Jun 11, 2006 7:03 pm

ssorry this is really my first dealings with this software. COuld you please provide some direction or give me some info on where i may find some. THank you all for your help