"Codeplug too new for this application"

wolfofoblivion · Post by **wolfofoblivion** » Tue Aug 29, 2006 11:21 am

I have read the section on getting around this roadblock in the batlabs section and was wondering if anyone has had any success with it. Also, is it possible to use a codeplug with a different flashcode to perform this trick without it bricking the target radio?

any help is appreciated.

Tom in D.C. · Post by **Tom in D.C.** » Tue Aug 29, 2006 2:07 pm

Post the radio model and RSS version you're trying to use.
Then someone can jump in and make suggestions.

wolfofoblivion · Post by **wolfofoblivion** » Thu Aug 31, 2006 3:05 pm

I was actually able to solve the problem without too much of a mess. Thanks though.

RESCUE161 · Post by **RESCUE161** » Fri Sep 01, 2006 3:50 am

wolfofoblivion wrote:I was actually able to solve the problem without too much of a mess. Thanks though.

But different radios use different methods for "getting around the roadblock" so to speak.

wolfofoblivion · Post by **wolfofoblivion** » Sat Sep 02, 2006 9:57 pm

The more I thought of it the more I became afriad of bricking my new AS, so I just decided to buy the new CPS instead. It was expensive, but not quite as expensive as I would imagine repairing a bricked AS would be.

Thanks again to all who were ready to offer their help.

"Codeplug too new for this application"

"Codeplug too new for this application"

CP too new...