Kenwood TK360G programming problem

MakCom · Post by **MakCom** » Fri Sep 22, 2006 3:21 am

Hi all,

I have a problem when trying to read or write to my TK360G...

The program says Check connection, first I thought i might be the cable, so I bought a new, but same problem... I have allso tryed other computers, but same problem...

Any one who can help?

Post by **wavetar** » Fri Sep 22, 2006 6:36 am

The 2-prong accessory connector is notorious for going bad (not just for Kenwoods, it can be in any radio which uses those)...do you know if a speaker mic works properly in it or not?

Todd

MakCom · Post by **MakCom** » Thu Sep 28, 2006 12:59 pm

Yes a speaker mike works ...

Post by **alex** » Thu Sep 28, 2006 1:26 pm

Just so you know - this is a Motorola board - not a Kenwood board.

If you want somewhere to post your kenwood issues - http://www.radioinfoboard.com will be your best bet.

I'll leave this post open, but for the most part, keep questions on this forum in it's entirity to Motorola.

-Alex

MakCom · Post by **MakCom** » Thu Sep 28, 2006 1:30 pm

Thanks...