Federal Signal 650 Jumper switches

Discussions regarding lighting, sirens, and other PS/Emergency response equipment can be had within this forum.

Discussions regarding legalities of lights, usages, and different state laws and regulations regarding warning equipment are not permitted.
See the announcement inside the forum for more details.

Moderator: Queue Moderator

Post Reply
MyoungARC
Posts: 14
Joined: Thu May 04, 2006 5:06 pm

Federal Signal 650 Jumper switches

Post by MyoungARC »

On the Federal Signal 650, there are 3 spots where jumpers can be arranged, my question is what does switching the jumper switches do. I played around with them myself, but I was unable to figure out what each configuration did.

Also I have the Federal Signal 650 Mod. 650001 which is the mod. that if the siren is on, and if you push the tone button is pushed, the siren switches from wail to priority, but on my unit it doesnt it just turns the siren off. What do I have to do to get it to the original configuration, which out using the horn ring switch.
Post Reply

Return to “Vehicle Warning Equipment Discussion”