XTS-5000 doing the 850 channels
Moderator: Queue Moderator
XTS-5000 doing the 850 channels
Two questions:
1. What is required to have an XTS-5000 go from the old 512 channels to 850 channels? Just the newer CPS? Firmware upgrade? flashcode upgrade?
2. If a XTS-5000 has 850 channels & is upgraded to FPP< Does it still go back down to 250 channels?
1. What is required to have an XTS-5000 go from the old 512 channels to 850 channels? Just the newer CPS? Firmware upgrade? flashcode upgrade?
2. If a XTS-5000 has 850 channels & is upgraded to FPP< Does it still go back down to 250 channels?
- spectragod
- Posts: 2029
- Joined: Sun Dec 30, 2001 4:00 pm
- What radios do you own?: FPP 6 meter XTL 5K's
Re: XTS-5000 doing the 850 channels
1) 7.00 or newer firnware I believe.123 wrote:Two questions:
1. What is required to have an XTS-5000 go from the old 512 channels to 850 channels? Just the newer CPS? Firmware upgrade? flashcode upgrade?
2. If a XTS-5000 has 850 channels & is upgraded to FPP< Does it still go back down to 250 channels?
2) The only radios I have seen FPP and 850 mode are trunking radios, in that case, then you are still limited to the 250 modes that are FPP, the rest (600) is trunking personalities.
SG
- compuman81
- Posts: 210
- Joined: Wed Feb 02, 2005 8:53 pm
Re: XTS-5000 doing the 850 channels
If you upgrade it to FPP it will become a 240 Channel Radio123 wrote:Two questions:
1. What is required to have an XTS-5000 go from the old 512 channels to 850 channels? Just the newer CPS? Firmware upgrade? flashcode upgrade?
2. If a XTS-5000 has 850 channels & is upgraded to FPP< Does it still go back down to 250 channels?
15 Zones of 16 Channels Each.
This is the standard setup for FPP.
The thing spectragod speaks of is a particular flash configuration that happens to include trunking and will permit you to have the 240 Channels modifyable via keypad and create an extra small set of personalities that the rest of the frequencies will reference to (option wise , signaling etc.) the tx/rx freqs, pls, dpls, Nacs and names can be configured though ( everything in the zone channel assignment page) you just can't setup different signalling, all that stuff for each of the remaining channels. Its really confusing I know.
-
- was grem467
- Posts: 1145
- Joined: Mon Jul 21, 2003 12:46 pm