XTS 3000 Firmware (MDC)

compuman81 · Post by **compuman81** » Sun Nov 19, 2006 9:27 pm

At what version firmware does MDC Delay of Silence and PTT ID start working at? For the life of me, I can't get it to work with this radio which has R06.10.02.

I have a radio with 5.6 in it, and it does it fine....I can't figure this out.

This couldn't have anything to do with the DSP version, could it?

jmr061 · Post by **jmr061** » Sun Nov 19, 2006 11:44 pm

Can you post the host/dsp and flashcode of both radios.

Jason

compuman81 · Post by **compuman81** » Sun Nov 19, 2006 11:56 pm

In question : 06.10.02 / 06.05.02
Works : 05.60.00 / 08.02.02

Both have Digital DSP

I have many other controllers with lower firmware/dsp that have never had a problem doing it, but I can't see anything else causing the problem.
Even The Astro Sabers with ancient firmware do it Alright.

jmr061 · Post by **jmr061** » Mon Nov 20, 2006 12:00 am

Whats the flash codes.

Jason

compuman81 · Post by **compuman81** » Mon Nov 20, 2006 5:45 am

problem radio has

imbe
h14
868/298 multikey/otar
conventional mode

tvsjr · Post by **tvsjr** » Mon Nov 20, 2006 10:00 am

Firmware mismatch? I don't think DSP8 is supposed to be in an R05.60 radio...

jmr061 · Post by **jmr061** » Mon Nov 20, 2006 10:09 am

I would agree with that, its possible since in the XTS3000 I believe the host and dsp are stored on different boards.

You should get both radios updated to newer stuff.

I dont think this would cause the problem however, but you never know.

Can you provide the flashcode of both radios, not what options it decodes to.

Jason

The Pager Geek · Post by **The Pager Geek** » Mon Nov 20, 2006 12:44 pm

Host

And or flash. MDC Options as well, missing.