HT1000 Speaker mic problems

EastTnLC · Post by **EastTnLC** » Tue Mar 13, 2007 9:53 pm

I try to connect a speaker mic to my Ht1000 and I hear nothing through the mic nor can I TX. I tried another mic just to see if it was my radio or the mic and it is my radio. I have checked all internal ribbon cables and all appears to be intact. Any ideas on what to do? Thanks!

kf4sqb · Post by **kf4sqb** » Wed Mar 14, 2007 8:37 pm

Try cleaning the contacts in the accessory connector.

Sky King · Post by **Sky King** » Tue Mar 20, 2007 9:33 am

Unfortunatly, we run into a LOT of these and usually it's a bad flex, even if it looks good visually. The flex can be gotten and replaced, if you have DTMF then it's much more difficult, we use a jig to line the pads up with the new flex and a hot air station to solder it. You can buy the complete flex with all the electronics attached. Good luck.

Bob