How to reset the RCH3000

MB · Post by MB » Wed May 23, 2007 7:40 pm

I had a power outage today and now my RCH3000 shows Fail 01/90 on the screen. It alternates from the screen that shows the firmware version to Fail 01/90 about every 10 seconds. Any idea on how I can reset the RCH300 or get this error to go away?

4n6inv · Post by **4n6inv** » Wed May 23, 2007 8:00 pm

Reset the control station and make sure it boots up OK. Unplug the wall wart for the RCH3000; give it 15 seconds and plug it back in. That should do the trick. If not; you have problems, my friend...

Post by **wavetar** » Thu May 24, 2007 9:44 am

Also check to make sure your consolette isn't on some kind of breaker which didn't come on when the power was restored. FL 01/90 means the remote isn't communicating with the consolette.

Todd

MB · Post by MB » Fri May 25, 2007 7:04 am

Fixed! After I reset the consolette and plugged the RCH3000 back in the system came up fine. Thanks for the help.