gp680 firmware f**k up

[radiomad]

Hello.
I'm sure this q has been asked before but.
I have a gp680 that i tried to flash into a 380 but in the middle of this the pc froze.
So basically i have a bricked 680.
Has anyone managed to revive their radio after this has happened?
I know that it's probably just going to be used as a paperweight, but any ideas would be really helpful.

[HLA]

run a search and you will find better directions but you will either have to send it in or use the method with a Y cable but that way you will need 2 radios.

[Andreas]

Read the messages on my homepage.
I think,you don´t programmed the lab codeplug first.
Flash the radio with the gp6xx lab firmware and program the gp3xx lab codeplug.
After this flash the gp3xx lab firmware.

Andreas

[11439]

I actually have a GP680, i swap the codeplug and firmware, for the firmware and codeplug for GP380

[Andreas]

if the radio will not work,start the lab upgradetool and program the radio with the hardware codeplug only or ty to program hardware and application codeplug only (Phase3).

Andreas