Is the power supply for the RLN1015D SmartRib the same as a standard rib (RLN4008) and if not what is the the power requirements for the SmartRib?
Mark
RLN1015D Smart Rib question...
Moderator: Queue Moderator
-
fail999
- Batboard $upporter
- Posts: 123
- Joined: Wed Sep 05, 2001 4:00 pm
- What radios do you own?: APX7K, XTS, XTL and on and on
Re: RLN1015D Smart Rib question...
The voltage and current requirements a virtually the same BUT good old mother /\/\ reversed the polarity of the connector. Center is ground, shell is positive.
fail999
fail999
-
N4DES
- was KS4VT
- Posts: 1234
- Joined: Thu Dec 25, 2003 7:59 am
- What radios do you own?: APX,XTS2500,XTL2500,XTL1500
Re: RLN1015D Smart Rib question...
I think I found the answer...center is negative and 9v is required.
So now for another one, why the 3 position switch? What does the difference between -, 0, and XP?
So now for another one, why the 3 position switch? What does the difference between -, 0, and XP?
Last edited by N4DES on Sat Sep 15, 2007 11:40 am, edited 1 time in total.
-
fail999
- Batboard $upporter
- Posts: 123
- Joined: Wed Sep 05, 2001 4:00 pm
- What radios do you own?: APX7K, XTS, XTL and on and on
Re: RLN1015D Smart Rib question...
Pretty sure this has been covered. Basically it switchs the internal uP frequency slightly to remove birdies that show up with some radios.
-
N4DES
- was KS4VT
- Posts: 1234
- Joined: Thu Dec 25, 2003 7:59 am
- What radios do you own?: APX,XTS2500,XTL2500,XTL1500
Re: RLN1015D Smart Rib question...
OK got it...thanks for the replies.