Good day all,
I have an MTS2000 UHF Model I that I have an MDC ID on 4 channels, with DOS (to mute the MDC noise) activated for all channels. My problem is, on the other channels, it lets the MDC1200 squawk pass, the DOS only works on the channels I have my MDC1200 ID set up for, how would I change that to have it activated on all channels ??
Thanks for the help ahead of time.
MTS2000 question
Moderator: Queue Moderator
-
MT2000 man
- Posts: 1307
- Joined: Tue Sep 04, 2001 4:00 pm
- What radios do you own?: XTS5000R, Astro Saber III, I
Re: MTS2000 question
my method of getting this to work, is to setup a new MDC system with any code you want, make sure to disable Pre-PTTID, and Post-PTTID, then setup the DOS settings for that MDC system. now affiliate the system with each channel that you desire DOS on, but no PTTID.
hope that helps!
hope that helps!
-
MT2000 man
- Posts: 1307
- Joined: Tue Sep 04, 2001 4:00 pm
- What radios do you own?: XTS5000R, Astro Saber III, I
Re: MTS2000 question
Hi,
Thank you for the reply. I will try that. It's odd because on my MT2000 I had a MDC PTT ID on a few channels, and DOS seemed to work fine on the other channels (the channels without my PTT ID). Thats odd.
Thank you again !
Thank you for the reply. I will try that. It's odd because on my MT2000 I had a MDC PTT ID on a few channels, and DOS seemed to work fine on the other channels (the channels without my PTT ID). Thats odd.
Thank you again !
Re: MTS2000 question
MT2000 man wrote:Hi,
Thank you for the reply. I will try that. It's odd because on my MT2000 I had a MDC PTT ID on a few channels, and DOS seemed to work fine on the other channels (the channels without my PTT ID). Thats odd.
Thank you again !
i had a similar experience, turned out that the local PD i was listening to had DOS on their repeater weird enough..