Minitor Trick ??

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
Cory516
New User
Posts: 2
Joined: Fri Dec 07, 2007 11:49 am

Minitor Trick ??

Post by Cory516 »

Minitor V.
2 ch. , A is sel call , B is open line and vibe (dont ask why , I guess thats what you get when the Fleet Mgr. programs pagers) both F1. C is sel call and D is open and vibe both F 2.

Can anyone tell me whats going on here ? I was holding the reset button and turned the pager on while on channel A , then 1 short beep and red light comes on , hit reset again it goes to green , hit again goes back to red and so on... also the voice replay button does the same , switch from A to B same also (I know channel C and reset and power on is programming mode) but if I switch to D in this mode I get open line and open squelch from F1(thats right F1 ??)

Turn it off and on again all seems to go back to normal.

Anyone know what I am doing here , I sure dont , but it's fun
tvsjr
Posts: 4118
Joined: Fri Nov 28, 2003 9:46 am

Re: Minitor Trick ??

Post by tvsjr »

Those are test modes. There's a button test, a stored voice test, and an RX test, along with program mode. You select the modes by turning the pager off, selecting A-D (C is program), holding the reset button, and turning it on.
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”