Our FD's are expierencing continuous pager sensivity issues since we switched to a new frequency a little over a year ago.
We are operating on a 12.5 frequency with 2575, 1130 and 832.5 pager tones. To my knowledge these are Plectron tone format, however the pager programming software rounds them slightly when you select this format. If you select "user" they round way off. The MIII and IV pagers will not accept the exact frequency. I have to round them to make it work. I was told by the radio shop to round up to the nearest frequency, but this gets us a few points closer to an another county nearby, causing alot of interference. With the freq of the channel and the tones a bit off, there are a few pagers that dont seem to always activate. I'm stumped.
I have heard you can make or obtain a program that will "force" the correct freqnency into the pagers, our radio shop does this. The issue is, if any other programming is needed, the motorola program will require you to correct the freqnency, as it doesnt allow the 12.5 spacing. Ugh!!
Any ideas?
Also, can anyone direct me to a better explanation of the alerting options (R168, R97 etc) The help menu ion the software is not too helpful for the explanations.
Minitor Tone Sensivity and Bandsplit Question
Moderator: Queue Moderator
Re: Minitor Tone Sensivity and Bandsplit Question
Just posting again to see if anyone has some feedback for these dusty, old, unanswered questions.
Thanks!
Thanks!