The lower part of the keypad (789,*0#) does not light up when the backlight comes on. This is a Panter radio, FWIW.
Is there a fix for this short of getting a new case?
XTS2500I Keypad Problem
Moderator: Queue Moderator
Re: XTS2500I Keypad Problem
Caveat Emptor in this case I'd say...
Consider the source and buy a new case. Perhaps look in the existing one for any water damage?
Consider the source and buy a new case. Perhaps look in the existing one for any water damage?
Re: XTS2500I Keypad Problem
Well the radio works flawlessly other than the keypad problem... so I figure the LEDs probably went on it. I did not see any water damage on the radio or housing anywhere.
Re: XTS2500I Keypad Problem
Swap to a known good case to verify what the problem is...
If a known good case is installed, and the keypad still doesn't work, something is fubar on the controller/rf board.
Cross your fingers that it's just the keyboard....
Good luck
If a known good case is installed, and the keypad still doesn't work, something is fubar on the controller/rf board.
Cross your fingers that it's just the keyboard....
Good luck

Re: XTS2500I Keypad Problem
Nothing wrong with the keys themselves... it's just that the LEDs don't work. Doesn't effect operation but it's a minor annoyance.
Oh well.
Oh well.