Convertacoms for my HT100 MTS 2000

This forum is dedicated to helping people with questions about installing radio equipment in vehicles. This can include antenna installs, electrical wiring questions/problems, and mounting systems. Pictures of installs are welcome.

Note: Discussions regarding lighting, sirens, and other equipment now has its own forum in the 'off-topic' section below.

Moderator: Queue Moderator

Post Reply
dalonzi
New User
Posts: 1
Joined: Fri Feb 29, 2008 2:12 pm

Convertacoms for my HT100 MTS 2000

Post by dalonzi »

Hello. The question I have is on the amplifiers both VHF and UHF units have power imputs on both ends. Do I run 2 power leads to each of the amps?.. Also they have two mini uhf female connectors one on each end. Do I connect the antenna on the RF in and do I need a jumper cable with mini uhf end to go to the cradle?
Top
resqguy911
Posts: 613
Joined: Sat Jun 26, 2004 3:35 pm

Re: Convertacoms for my HT100 MTS 2000

Post by resqguy911 »

Yes, you need to power both sides (fused separately) of the control box. One side is the brain, the other is the RFPA. You also need a mini-u to mini-u jumper from the cradle to the input of the control box, then connect your antenna to the RFPA to get the full potential of your MTVA.
"TDMA = digital and same great taste, half the bits"
Top
Post Reply

Return to “Vehicle Radio Installs”