MCS2000 high power ignition sense question

Post by **FIRE6115** » Thu Apr 07, 2011 4:51 pm

I have a mcs2000 model 3 110w remote mount
I bought a ignition sense plug and it does not seem to work
Any ideas??

JeffFireRadio · Post by **JeffFireRadio** » Fri Apr 08, 2011 5:00 am

Hello. Are you aware that the MCS2000 (and most other modern M mobiles) require a software setting to acknowlege your ignition sense desires in addition to a proper wiring configuration? If you're sure that you're wired correctly (power cable, ignition sense cable and proper pin positioning), I would start with the programming. I have three in my vehicle (two high power units) and have addressed this during their installation. Best wishes.

- Jeff

Post by **FIRE6115** » Sat Apr 09, 2011 7:04 am

No I did not know that but I will Check what field is it under in the CPS

Thanks

MP 6.7 · Post by **MP 6.7** » Sat Apr 09, 2011 10:13 pm

Radio Configuration, Radio Wide, Advanced tab, Ignition switch dropdown menu. Yours is most likely set to "blank" if the ignition sense wire does nothing.

MCS2000 high power ignition sense question

MCS2000 high power ignition sense question

Re: MCS2000 high power ignition sense question

Re: MCS2000 high power ignition sense question

Re: MCS2000 high power ignition sense question