XTS5000 Narrowband

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
joes243
Posts: 68
Joined: Tue Apr 20, 2010 9:44 am

XTS5000 Narrowband

Post by joes243 »

Hello All-
I tried searching, but I can't find anything on this. Does anything need to be done in an xts5000 to set a Rx only channel to narrowband? I see the Tx Opt Transmit Dev setting for transmitting, but nothing for receiving and this setting is not enabled on Rx only channels.

Thanks for any help!
Top
mike m
Posts: 903
Joined: Mon Sep 03, 2001 4:00 pm

Re: XTS5000 Narrowband

Post by mike m »

Once you set the TX dev to 2.5KHz the RX is also automatically set to 12.5KHz Channels automatically.
Top
Will
Posts: 6823
Joined: Tue Sep 04, 2001 4:00 pm

Re: XTS5000 Narrowband

Post by Will »

mike m wrote:Once you set the TX dev to 2.5KHz the RX is also automatically set to 12.5KHz Channels automatically.
Correct, set the RX and TX freqs and set the TX Dev to 2.5khz, then set that channel/mode to RX only.
Top
joes243
Posts: 68
Joined: Tue Apr 20, 2010 9:44 am

Re: XTS5000 Narrowband

Post by joes243 »

Thanks guys. On a Rx only personality, the Tx Dev field is not enabled (greyed out). What I have been doing is making the personality Rx & Tx, change the Tx Dev to 2.5 and then make the personality back to Rx only.
Top
Post Reply

Return to “Radio Programming”