Motorola Minitor III OR IV on Ham
Moderator: Queue Moderator
Motorola Minitor III OR IV on Ham
Tried a Motorola Minitor 3 yesterday and successfully changed it to ham using engineering mode, however it appeared deaf. Anyone know how to tune these things to improve sensitivity?
Re: Motorola Minitor III OR IV on Ham
Your problem is probably a hardware issue. Minitors came in different frequency ranges. The "tuning" is done by the test software.
Mods - You might want to move this to Digital & voice paging.
Mods - You might want to move this to Digital & voice paging.
Dave
Re: Motorola Minitor III OR IV on Ham
OK, Well like I said I changed it in engineering mode to 141-149 or something like that just trying to get it to receive better.
-
- Posts: 613
- Joined: Sat Jun 26, 2004 3:35 pm
Re: Motorola Minitor III OR IV on Ham
What split was it originally? Just because you hack the software doesn't mean the receiver will tune that far. My experience was that they only swing a few MHz in each direction from factory.
"TDMA = digital and same great taste, half the bits"
Re: Motorola Minitor III OR IV on Ham
Was 151-159 but changed it in Eng mode to the ham band. Just would like to know how to tune or whatever to improve receiving capability or do whatever it is to make it happen.
Re: Motorola Minitor III OR IV on Ham
Agreed, and done.DJP126 wrote:Mods - You might want to move this to Digital & voice paging.
Re: Motorola Minitor III OR IV on Ham
As stated earlier, "tuning" is done by the software. Your hardware (the pager's rf receiver) is for 151 to 159 MHz, the ham bands are too far away to receive. You would have to re-engineer the hardware to receive those frequencies.
Dave
-
- Posts: 59
- Joined: Fri May 15, 2009 12:52 pm
Re: Motorola Minitor III OR IV on Ham
I have had some luck getting a 151-159 split to receive in the ham band. I guess some rf boards will go further out than others. Check out this video on you tube I haven't had a lot of luck with this method. But I have only tried it to get a 450 split minitor into the 70cm ham band. It may be worth a shot. Especially if you have any sort of test equipment.
http://www.youtube.com/watch?v=RjQIjnc3rJY
http://www.youtube.com/watch?v=RjQIjnc3rJY
Re: Motorola Minitor III OR IV on Ham
Still looking for help. Would be even better if I could find a pager that would do 443 mhz!