hi everyone, ive searched the site and havent seen anything that addresses my question.
i have a GR300/GR400 Repeater with 2 GM300 mobiles.
the mobiles are programmed with the correct accy pins and it does receive and transmit as it should.
the RX mobile is programmed with 103.5 RX pl and the TX radio is programmed with 103.5 PL
it will rx and rebroadcast what it hears on the input to the output as any normal repeater would, the only issue is, theres no TX pl, even tho the mobile is programmed with it.
i dont see any option in the ZR340 setup manual to affect pl, or atleast not in common terms.
i have tried 2 TX mobiles, and 3 ZR340 controllers, they all work the same, repeat fine, no TX pl.
ive even reset the controllers to factory default....
any ideas????
GR300 no TX PL with ZR340 Controller
Moderator: Queue Moderator
-
wazzzzzzzzup
- Batboard $upporter
- Posts: 751
- Joined: Thu Oct 04, 2001 4:00 pm
- What radios do you own?: XTS3000/astro spectra/
GR300 no TX PL with ZR340 Controller
think about how to ENCOURAGE Motorola learning safely with GRACE.....NOT condemnation.
-
jackhackett
- Posts: 1518
- Joined: Tue Jun 10, 2003 8:52 am
Re: GR300 no TX PL with ZR340 Controller
Do they transmit PL when you key them with a microphone?
Make sure the jumpers in the RX and TX radios are setup properly according to the GR300-500 service manual. Also go over the ZR340 setup procedure in the service and RSS manuals and make sure you didn't miss anything.
Make sure the jumpers in the RX and TX radios are setup properly according to the GR300-500 service manual. Also go over the ZR340 setup procedure in the service and RSS manuals and make sure you didn't miss anything.